-
Legacy Member
Last edited by Vincent; 02-22-2016 at 07:21 PM.
-
-
02-22-2016 07:18 PM
# ADS
Friends and Sponsors
-
Legacy Member
Not quite relevant to the Q Vince but photos of these are quite hard to source. My friend from darkest Devon went to |India and asked a railway guard if he could photograph his Sterling but he declined and slung it behind his back. At the next opportunity he tried the same ploy by asking NOT about the Sterling, but could his wife stand next to him for a photo. No problem....., but the gun went behind!
Ah! That explains what’s going on here. 
Last edited by Vincent; 02-22-2016 at 09:34 PM.
-
-
-
Advisory Panel

Originally Posted by
Lee Enfield
they are clearly are using a single recoil spring
That's all we used...
-
-
Legacy Member

Originally Posted by
Lee Enfield
I watched the video again, I wonder if the external loop has been switched from the left side to the right side by re installing it reversed?
I was wondering the same thing.
It looks like the front of the suppressor is welded on to the tube. So the barrel and the baffels must come out the other end.
I guess the high sights are needed to see over the ring in front of the magazine housing.
-
-
The higher backsight is because the sight on the silenced gun is calibrated for 25 and 50 yards instead of 100 and 200 as per the norm.
-
Thank You to Peter Laidler For This Useful Post:
-
Advisory Panel
The higher backsight is because the sight on the silenced gun is calibrated for 25 and 50 yards instead of 100 and 200 as per the norm.
According to the Sterling Mark 5 user manual, the rear sight on the Mk5 has both positions calibrated for 100 yards(or meters). One for daylight, and the other aperture for "low light" conditions such as dusk and dawn...
On the previous page it does say something about the typical range for use as being 25 to 50 yards as I recall, though a "skilled user" should be "easily" able to take shots out to 200 yards...
Attachment 70487
Last edited by Lee Enfield; 03-01-2016 at 03:51 PM.
-
Thank You to Lee Enfield For This Useful Post:
-
Legacy Member
Why would they have deleted the 200 yard sight if that were the case?
My very limited experience with the Mk5 makes me think it’s has an effective tactical distance of around 50 yards. So much gas is vented off through the barrel ports to keep the bullet subsonic. That robs a lot of energy.
There’s also the front sight, it’s much too coarse for long distances. You also have to deal with a considerable heat mirage when the suppressor gets hot. That’s probably one reason for the full length thermal sleeve on the Indian gun. The high gloss paint has me baffled. Any ideas?
-
-
L-E is right, the sight is a short range sight. It is the reduced m/v that makes it higher. The 'secondary' low light aperture is the 'button hole' thinggy.
I think the gloss paint answer is the same as the glossy No1 and 4 rifles. They bought a zillion gallons back in 19-whenever and have been using it lavishly, smothering everything in it ever since!
-
Thank You to Peter Laidler For This Useful Post:
-
Legacy Member
-
-
Advisory Panel

Originally Posted by
KUNAL BISWAS
Thank you, do you have any other photos?
-