M1 INLAND RARE MID SIGHT

[EddieM]

Ole Eddie must be dipping in to the stash,
Breaking the cardinal rule !



Breaking the law........ Breaking the law.......

Hey Loco
Your cartel specials is almost ready

No tool needed to remove the slide, watch the video below.

Tx Wayne.

Guys here are some pics with marks that I found

[EddieM]

Hey guys,
Take a look, is it me or in this pic it seems to be an emoji smiling devil lol

[painter777]

Might be time to put that out and park your ride Eddie.....

[EddieM]

Might be time to put that out and park your ride Eddie.....

https://www.milsurps.com/images/impo...w960h500-1.jpg

Hey Charlie
What for did you ask me those flat barrel marks?
Regards
Eddie

[painter777]

To see the markings on it.
The pictures show markings put on by Inland that are thought to be their inspection markings.
So we now know you have a Inland barrel.
The WI on the front of the Gas Cylinder tells us it's also Inland.

Got my order ready?

[EddieM]

To see the markings on it.
The pictures show markings put on by Inland that are thought to be their inspection markings.
So we now know you have a Inland barrel.
The WI on the front of the Gas Cylinder tells us it's also Inland.

Got my order ready?

Awsome Charlie.
Tx for the feed back, so do I have an Inland or a Rock Ola?

[painter777]

Eddie,
Serial number is the maker- You have a Inland.
You have a Inland receiver with what is probably the original Inland barrel.... Minus the modifications by being cut shorter.
The Rock Ola parts aren't original to it, but Rock Ola parts are really expensive.

So far I see you have Rock Ola:
Recoil Plate
Front sight
Trigger housing with rear beveled corners..... probably a Type II
Hammer- Type III straight hammer
Op Slide.

Look closer at your Flip Sight with the S on it. Look for a WI stamped on the front side of the tallest leaf (below the peep hole)
Look at your barrel band and the attached swivel for any markings like UI or other letter markings.

Should look at the left and right lugs on your Bolt for any markings ??
See if you can see any letter markings on your Sear and Trigger..... and look at the front teeth of your Magcatch, where the back of your magazine clicks on for letter markings.

For trigger housing parts this link will give you an idea of where to look on pages 2, 3 and 4: The U.S. Caliber .30 Carbines - Trigger Housing Group

For Bolts: The U.S. Caliber .30 Carbines - Parts

For Barrel band and Swivel: The U.S. Caliber .30 Carbines - Barrel Manufacturers

HTH,

Carlos-P777

[W5USMC]

Look for a WI stamped on the front side of the tallest leaf (below the peep hole)

Isn't the WI on the back side of the shortest leaf on those Inland flips that have it?

[painter777]

Isn't the WI on the back side of the shortest leaf

Now I don't remember Wayne, I'll look at one when I get back.

[deldriver]

No need to look, I pulled mine out of the drawer and the WI is on the front of the shorter aperture.