Carbine Not Firing

[painter777]

Thanks Dave HH,
That was sorta my point.
Bolt tool is a must especially if you plan to use that carbine to go bang.

Charlie

[MAG176]

I would like to thank everyone for all the ideas.l I gave the bolt a good cleaning and soaked it over overnight. Took the suggestion of buying a bolt tool so I could clean it properly. While looking at the bolt a bit more carefully, and using a magnifying glass I got an idea about how it should work.
I found that both the ejector and the extractor were frozen. Little Rem oil and a bit of taping and everything is moving like it should- I hope anyways.Guess the bolt wasn't closing all the way after all and wasn't striking the firing pin, but most you all ready knew that. So when the tool shows up ill give it a good cleaning.
Any ways found a lot of part numbers and other markings I didn't spot before. Hey, this is kinda fun.

Thanks Again, Mark

[shadycon]

Any ways found a lot of part numbers and other markings I didn't spot before. Hey, this is kinda fun!
Have you been fishing lately? Because now you are HOOKED!!!!