-
Legacy Member
CAI L1A1....buttstock question
During my recent dip into "all things L1A1" world...I came across a verbal reference to Century Arms manufactured butt stocks that were "lightweight and flimsy/cheap?)".
How can one tell an original British military part from the CAI part?
As always, thanks for the anticipated cooperation.
Mike
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
"Audacia....By daring deed"
-
-
06-02-2018 12:14 PM
# ADS
Friends and Sponsors
-
Contributing Member
Are we talking wood or plastic here Trooper?
Plastic, Mainly British, with some NZ variations.
Wood, well, British early butt was Walnut without vertically added reinforcing strips at the wrist.
The strips were added to prevent splitting that occurred at this weak point.
So Walnut without strip, then with, finally a switch to Beech before it was all replaced with considerably more practical plastic.
Australia, thicker profile coachwood in a couple of variations.
Canada, over to you Jim, you tell me but my memory is terrible these days!
Whatever the make, look under the wrist for manufactue and length. S,M,L
UK
E Enfield
B BSA
Australia
SLZ Slazenger (is that spelt right)?
MA. Lithgow
-
Thank You to mrclark303 For This Useful Post:
-
-
Legacy Member
sorry for not being clear...specifically looking at a black plastic stock. Looks unmarked, and with a pebbled black finish.
The reason I ask, is it has a ill-fitting Century Arms marked rubber butt pad, that mounts with 2 screws (not the typical butt screw/butt plug arrangement.
These pix should help.
Is just the rubber a Century part, or the entire assembly?
Attachment 93735
Attachment 93736
Attachment 93737
"Audacia....By daring deed"
-
-
Advisory Panel
That's an original pebble grain British plastic stock with a CAI buttlate. I forget what mods are done to accommodate the aftermarket buttplate. I can fix you up with an original buttplate and/or stock if in need. I have the buttplates in different lengths too. Contact me off forum if in need.
-
-
Advisory Panel
Ours were always Walnut...
-
-
Legacy Member
So I replaced the rubber Century part with the proper butt pad. Looks much better, I think....
Attachment 93748
(I know the jacket shoulder patches and the optic scope are not "proper" but I could not resist. Ever since reading "A Bridge too Far" as a kid, I have had a fascination with British paras.....and that stuck with me to this day, even as a former 82nd Airborne trooper!
"Audacia....By daring deed"
-
-
Legacy Member
Everything Century Arms has ever manufactured is suspect at best. They have no concept of QC. And they think nothing of mixing inch and metric parts as they assembled rifles, of all kinds, out of parts bins.
"...length. S,M,L..." S, N, L, XL. Short, Normal, Long, Extra Long. And if it's not right for you, you get whacked, hard, on the cheek bone.
Spelling and Grammar count!
-