-
Legacy Member
Action Screw Torque
Anyone know what the torque should be on the action screws on a K31. Mine were quite loose so i put them up to 35 in/lbs . Too much or not enough?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
02-19-2016 06:30 PM
# ADS
Friends and Sponsors
-
Contributing Member
Torque
From what I could find on the subject 35/inch lbs seems to be the go I got that on google which took me to an old milsurps thread you can also use the search engine top Rt on milsurps
page.
-
-
-
Legacy Member
Thanks. Had a lucky guess then. Just seemed to be a good place to start.
-