-
Legacy Member
Unertl scope block question.
On the M1941 receiver scope block were the screw holes drilled completely through the receiver or not. I was talking with a gentleman that said they were drilled through but it seems I read on the old forum that they were 1/8" deep. Thanks SteveL
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-13-2009 11:54 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
I read that the 6x48 thead was only three or four threads deep so that they did not punch through.
-
-
Advisory Panel
If I am not mistaken, they were drilled with a "mill" bit (flat on bottom) and tapped with a bottoming tap 4-threads deep. Not sure where I read that, or if I dreamed it up. Take it for what it is worth.
Not as easy as it sounds anyway, as that is only 0.083" of an inch deep.
Jim
-