-
FREE MEMBER
NO Posting or PM's Allowed
Type 3 Hammer ID question?
-
06-13-2011 08:02 PM
# ADS
Friends and Sponsors
-
Senior Moderator
(Milsurp Forums)
I think we covered this some time back and they are replacement hammers. There were a number of companies making replacement parts that are not listed in Riesch's book.
Last edited by Bill Hollinger; 06-13-2011 at 09:35 PM.
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
thanks. they are not M2 cut on the reverse.
-
Legacy Member
The hammers were made by Kal Machine Works. The two marked I.K. were intended for Inland. The one with the R stamped over the I, now reading R K. was redirected to Rock-Ola from Kal.
-
-
Legacy Member
My NPM has a KR hammer
These were made directly for Rock-ola? RK being marked after production and sent to R?
-