Help-Advise on shooting a SC 6-43 barrel that has been modified

[tomwatts]

I just acquired a SC 6-43 on flie-bay, and I thougt the picture here showed a SC with a barrel shim, so I bought it anyway. (SC barrels are hard to come by!)

Turns out that's no shim, the shoulder has been cut back leaving a sliver of the shoulder in place. The barrel mounts fine and indexes snug with good head space.

Attachment 30282
My questions are:
1. Is this barrel safe to shoot?
2. If its not safe to shoot, can it be saved, by a gunsmith with the proper tools?

Thanks is advance for any advise!

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Cosine26]

It looks to me as if someone made a rerlief cut to remove the barrel from a receiver. I do not believe that the barrel will stand up for much shooting as it is, even though it indexes correctly and fits snug against the remaing barrel material. The only hope is to move the shoulder forward and recut the threads. It will be necessary to cut a new feed cone and extractor cut and rechamber. The barrel will then be short. As a sporter it MAY be OK but if you are looking to restore an original SC, it will always be incorrect and will look funny. I have had this done with 03A3 barrels for installing on Gew 98's and it seems to work out OK, but those were for shooters not for restoration. I would not recommend rechambering for a Magnum caliber but a standard caliber it may work out. This is not a recommendatioin - just relating my own personel experience.
Someone with more knoweledge, please feel free to opine.
FWIW

[Chuckindenver]

barrel is junk...

[Calif-Steve]

This is a flea-bay deal? I would send it back tomorrow.

[Emri]

barrel is junk...

I'll second Chucks statement. (as far as using "as is" on a rifle.)

[Chuckindenver]

might be great for a jack handle, or holding a flag, tomato stake, but since a lazy gunsmith cut the shoulder, rather then man up and crank it out...it destroyed that barrel.
another reason...i dont cut them...wrench marks can be fixed...that cant.

[tomwatts]

To quick to give good feedback, much to easy going...

It really looks nice inside and out, except for the shoulder.

Another lesson on auction pictures etc.

[Chuckindenver]

i have a SC barrel that id sell..bore is a little frosty, but safe to shoot.

[tomwatts]

I will e-mail you Chuck!
Thanks
Tom

[Salt Flat]

Tom, I have utilized 2 barrels that were cut like yours. Breeching washers were made to get the proper crush and clocking. I have seen this done on many rifles. However, this is not an easy job and when you are done the collector value is significantly reduced. The barrels I used worked out great for shooters. There are precedents to support the use of the washers. Breeching washers and shims have been used on many production rifles as well as for repair. Examples are the Enfield No. 4's and the L1A1. The Remington 700 and Savage 110 use a recoil shoulder that is essentially a breeching washer. Check out this article: http://photos.imageevent.com/badgerd...ching%20Up.pdf