-
FREE MEMBER
NO Posting or PM's Allowed
Small parts.
If you found these in the same Carbine, what would you think ?. I know Inland and IBM used BI . Just another unsolved question. Mike.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
12-02-2011 02:34 AM
# ADS
Friends and Sponsors
-
The trigger looks like "RI "and the sear "B1." What's the marking on the hammer? - looks like a "5" on my screen. Is the mark "GI"? My guess is the gun is an Inland. I've got a spare Type 2 hammer marked R.I. and I think it's an Inland. - Bob
Attachment 28589Attachment 28590
Last edited by USGI; 12-02-2011 at 03:24 PM.
-
Thank You to USGI For This Useful Post:
-
-
Legacy Member
Not an S but a five, on the hammer.
I always thought small BI on the sear side was Inland, Large BI or B1 IBM. Or maybe the other way.
-
Thank You to Bubba-7 For This Useful Post:
-
I don't know if it's an error in Riesch's book, but it shows the IBM sears with these markings only in the Type 2. - Bob
-
Thank You to USGI For This Useful Post:
-
Legacy Member
The stamp on the sear looks like an IBM B1 not a BI. I did check WB and there is no listing of IBM sears going to Inland.
-
Thank You to Bruce McAskill For This Useful Post: