-
Legacy Member
M1 bayonett without a guard - need help
I have just the blade of an AFH bayonett with the 2 holes in the tang. Has anyone had experience installing a guard? What should I use for the pins in the holes?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
10-14-2011 06:23 PM
# ADS
Friends and Sponsors
-
Advisory Panel
The pins have to be soft enough to flare into the opening. They aren't that hard to begin with but they aren't say...nails. On the other hand I wouldn't use a drill bit either. Something in between. I was lucky and had the original pins to work with. The hardest part I think will be getting the correct size.
-
-