-
FREE MEMBER
NO Posting or PM's Allowed
loose cocking piece 303 no.4
Can anyone give me a good way take the play out of the cocking peice to firing pin fit.
Thanks
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
09-16-2009 07:49 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
The correct way is to peen slightly the first three treads on the end of the rod. A tool for doing this was made from a slab side cocking piece. The easy way to do it is a drop of blue locktite. Allow the locktite to cure for several hours before you reinstall the lock screw. No need to locktite that little screw.
Last edited by JBS; 09-17-2009 at 11:28 AM.
-