-
FREE MEMBER
NO Posting or PM's Allowed
9mm Brass wont fit into my Resizing Die??????????????????????
I picked up 1200+ - Allegedly "once fired" While sorting it and inspecting/culling out brass I ended up with about 600 or so unfired pieces .
upon resizing some I kept running into "MAL 85 9mm" that would not go into the Die and I will not force it. Any thoughts Please Chime in as I am at a loss here
Pretty sure the MAL is Malaysian surplus as I have plenty of 5.56 on hand
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
01-01-2011 01:11 AM
# ADS
Friends and Sponsors
-
Advisory Panel
I don't quite follow. Carbide die or lube? Won't even start or just swelled at the base? Need a bit more detail.
-
-
-
FREE MEMBER
NO Posting or PM's Allowed
My Bad (LOL)
It is Dillon Carbide Dies , and it will not Start and I am not going to force it, all other brass Win Rem PPU Horn all go in without issue
Will take Dimensions of it and Post Pics
-
Advisory Panel
OK but if they're carbide dies they should be fine. I'm using my Dillon right now with .45 and you get hard size and easy. No difference. I still think it's just a bit of base swell and you shouldn't worry. Which Dillon is it? Mine's a 550 RL. No bells and whistles. Older one.
-