-
FREE MEMBER
NO Posting or PM's Allowed
Carbine tool
Here are pictures of a wrench for gas piston nut, at least I think it is, it fits.
I should have put a ruler in the picture, but it is 5.5" long. Fairly rough forging.
Has a stamp, hard to tell what it is, appears as an "X" or something close. No ordinance marks.
Any ideas or definite answers?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-11-2010 06:54 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Could be a K for Kingsbury tool mfg. who made them.
Scott
-
-
Advisory Panel
(Deceased Feb 2023)
The K is located in a different position on the tool. This is an X , which was Hadley Specialty Tool, in Mass.
-