+ Reply to Thread
Page 1 of 3 1 2 3 LastLast
Results 1 to 10 of 24

Thread: Found in a loft....

Click here to increase the font size Click here to reduce the font size
  1. #1
    Advisory Panel Thunderbox's Avatar
    Join Date
    Dec 2008
    Last On
    01-10-2022 @ 02:07 PM
    Posts
    1,150
    Local Date
    05-01-2024
    Local Time
    07:03 PM

    Found in a loft....

    One of the very few benefits of living in UK these days is that there still remain a host of undiscovered Lee Enfield treasures concealed in lofts and attics of houses around the country.

    Probably thousands of rifles and pistols were secreted away after WW1 and WW2 - weapons "misplaced" by soldiers, souvenir'd off battlefields, or pinched by kids from the depots that used to cover the country.

    Sadly, most of these weapons end up being handed to the Police and quickly destroyed. A very few are handed in to registered dealers and "legitimised".

    This rifle was found by someone, buried in the mica roof insulation in the loft of their house. The previous two owners of the house knew nothing about the rifle's presence, and so far no link has been discovered to a possible wartime owner.

    The rifle is a 1915 No1 MkIII, with typical WW1 re-stock. It is 100% all-matching including its original 1915 barrel and - when hidden - was in near mint military issue condition. The rifle provides a wonderful specimen example of what an actual Britishicon military SMLE looked like, before 60+ years of abuse at the hands of subsequent civilian owners:

    - the fit of forend and other parts is superb;
    - screwheads are untouched and mostly staked;
    - the bolthead is tight in line with the bolt rib;
    - the barrel is cosmolineicon'd under the wood;
    - the handguards appear to be new.

    When rifle had no wrapping or cover when found, and so had suffered extensive surface rusting:



    The butt contained a pull-through, complete with the last piece of flannelette used!











    1915 barrel date - and no civilian proof marks at all....!





    Interestingly, the sling appears to be stamped "N/\Z". Other marks are too faint to make out:




    The screw heads are all "un-buggered" (REME technical phrase, apparently, according to Peter Laidlericon......)




    The corrosion had attacked the metalwork to varying degrees - presumably depending upon the surface finishing of the individual component. The receiver body cleaned up surprisingly well, using just wire wool and oil. Other parts - the bolt knob, bands, sling swivels and nosecap - were more deeply rust-pitted and required more aggressive cleaning. These parts now have a faint stipple and "plum" colour of rust staining. The wood was undamaged, and responded immediately to cleaning with turps/RLO mix.












    So far, the rifle has cleaned up quite well. The bore had been unprotected by any greasing or thick preservative. A patch only removed a very slight trace of greenish film. Whatever it was - and I assume it was issue Rangoon oil - it did an amazing job: unbelievably, the bore is bright and shiny, and appears to have fired just a couple of hundred rounds since new!
    Information
    Warning: This is a relatively older thread
    This discussion is older than 360 days. Some information contained in it may no longer be current.


  2. # ADS
    Friends and Sponsors
    Join Date
    October 2006
    Posts
    All Threads
    A Collector's View - The SMLE Short Magazine Lee Enfield 1903-1989. It is 300 8.5x11 inch pages with 1,000+ photo’s, most in color, and each book is serial-numbered.  Covering the SMLE from 1903 to the end of production in India in 1989 it looks at how each model differs and manufacturer differences from a collecting point of view along with the major accessories that could be attached to the rifle. For the record this is not a moneymaker, I hope just to break even, eventually, at $80/book plus shipping.  In the USA shipping is $5.00 for media mail.  I will accept PayPal, Zelle, MO and good old checks (and cash if you want to stop by for a tour!).  CLICK BANNER to send me a PM for International pricing and shipping. Manufacturer of various vintage rifle scopes for the 1903 such as our M73G4 (reproduction of the Weaver 330C) and Malcolm 8X Gen II (Unertl reproduction). Several of our scopes are used in the CMP Vintage Sniper competition on top of 1903 rifles. Brian Dick ... BDL Ltd. - Specializing in British and Commonwealth weapons Specializing in premium ammunition and reloading components. Your source for the finest in High Power Competition Gear. Here at T-bones Shipwrighting we specialise in vintage service rifle: re-barrelling, bedding, repairs, modifications and accurizing. We also provide importation services for firearms, parts and weapons, for both private or commercial businesses.
     

  3. #2
    Administrator

    Site Owner
    Badger's Avatar
    Join Date
    Oct 2006
    Last On
    @
    Location
    Toronto, Canada
    Age
    75
    Posts
    12,946
    Real Name
    Doug
    Local Date
    05-01-2024
    Local Time
    03:03 PM
    My Videos in Video Club
    12

    Thumbs up

    Awesome ....

    Thanks for posting the pics and the background ...

    Regards,
    Badger

  4. Avoid Ads - Become a Contributing Member - Click HERE
  5. #3
    Moderator
    (Milsurp Forums)


    Amatikulu's Avatar
    Join Date
    Dec 2007
    Last On
    12-30-2023 @ 05:23 PM
    Location
    USA
    Posts
    1,282
    Local Date
    05-01-2024
    Local Time
    02:03 PM
    I note that the rifle has:

    1. Piling swivel (assume large size)
    2. small nose cap screw head
    3. Windage adjustable rear sight
    4. butt stock disk (any markings?)
    5. Magazine cutt-off
    6. oval cocking piece
    7. dimpled rear site protector

    Who was the manufacturer?

    It's very interesting as I can see the stock is missing the volley sites and assume this is what you mean is a typical WW1 restock.

    Do you think it was restocked post WW1?

  6. #4
    Legacy Member Mr303's Avatar
    Join Date
    Aug 2008
    Last On
    07-26-2023 @ 09:52 PM
    Location
    New Zealand
    Posts
    39
    Local Date
    05-02-2024
    Local Time
    07:03 AM
    Nice find, it cleaned up very well. A bit of elbow grease and steel wool can do wonders, I did a similar job with a Metford and a No1 that I bought, they had been sitting in a wool shed for 50 years and were pretty filthy. Good on ya.

  7. #5
    FREE MEMBER
    NO Posting or PM's Allowed
    bradtx's Avatar
    Join Date
    Jan 2009
    Last On
    11-29-2010 @ 08:01 AM
    Location
    Pearland, TX
    Posts
    302
    Local Date
    05-01-2024
    Local Time
    01:03 PM
    Thunderbox, Will it be made 'legit'? What luck to at least pass through your hands.

    Brad

  8. #6
    Advisory Panel Thunderbox's Avatar
    Join Date
    Dec 2008
    Last On
    01-10-2022 @ 02:07 PM
    Posts
    1,150
    Local Date
    05-01-2024
    Local Time
    07:03 PM
    Thread Starter
    Quote Originally Posted by Amatikuluicon View Post
    I note that the rifle has:

    1. Piling swivel (assume large size)
    2. small nose cap screw head
    3. Windage adjustable rear sight
    4. butt stock disk (any markings?)
    5. Magazine cutt-off
    6. oval cocking piece
    7. dimpled rear site protector

    Who was the manufacturer?

    It's very interesting as I can see the stock is missing the volley sites and assume this is what you mean is a typical WW1 restock.

    Do you think it was restocked post WW1?

    Its an Enfield-made rifle and, apart from the replacement forend, every part is marked "EFD" and appears to be original to the rifle.

    The general configuration is correct for the "inter war" standard of MkIII SMLE, with the possible exception of the small nose cap screw and the windage sights (which only have one rifle number on them - matching this rifle - instead of six or seven rebuild numbers).

    What is interesting is that the original barrel has had so little use that it implies the "old" forend with volley sights can't have been much damaged by service use when it was replaced. Perhaps they simply FTR'd the MkIIIs and got rid of the volley sights anyway? That would explain why so few of them survive.

    This rifle has no markings other than its set of 1915 proof & inspection marks. There appear to be no FTR or refurb inspection stamps at all, which possibly indicates that the forend was a wartime field workshop replacement. If the rifle was 1916 or later, I'd have speculated that it was even built with this "transition" forend - unlike most restocked MkIIIs, this one has a perfect match in colour & wear between butt & forend.

  9. #7
    Advisory Panel Thunderbox's Avatar
    Join Date
    Dec 2008
    Last On
    01-10-2022 @ 02:07 PM
    Posts
    1,150
    Local Date
    05-01-2024
    Local Time
    07:03 PM
    Thread Starter
    Quote Originally Posted by bradtx View Post
    Thunderbox, Will it be made 'legit'? What luck to at least pass through your hands.

    Brad
    Its "legit" now that its on my dealer register. UKicon firearms law allows for dealers to accept anonymous "hand ins" - this was historically necessary because of the thousands of wartime guns like this hidden away. Dealers are not even obliged to inform the Police - but generally do if there is any chance the weapon might be stolen or otherwise connected to a crime. Rusty service rifles of obvious wartime vintage have generally been regarded as untraceable and of little relevance to the Police. Unfortunately these days many UK police forces have decided to make up their own laws without reference to Parliament, which is why I have chosen not to show this rifle's number or butt disk marks. Unfortunately, it pays to be paranoid in UK these days.....

  10. The Following 2 Members Say Thank You to Thunderbox For This Useful Post:


  11. #8
    Legacy Member Strangely Brown's Avatar
    Join Date
    Mar 2009
    Last On
    Today @ 05:31 AM
    Location
    Wiltshire UK
    Age
    72
    Posts
    553
    Real Name
    Mick Kelly
    Local Date
    05-01-2024
    Local Time
    08:03 PM
    Was there a unit marking on the butt disc?
    Mick

  12. #9
    Senior Moderator
    (Founding Partner)


    Site Founder
    Claven2's Avatar
    Join Date
    Oct 2006
    Last On
    08-09-2023 @ 10:17 PM
    Location
    Scandaltown, Ontario
    Posts
    3,242
    Real Name
    Ronald
    Local Date
    05-01-2024
    Local Time
    02:03 PM
    Being a 1915, it cold have been made late in the year or assembled early in 1916 as a transitional and may never have been fitted with volley sights.
    Союз нерушимый республик свободных Сплотила навеки Великая Русь. Да здравствует созданный волей народов Единый, могучий Советский Союз!

  13. #10
    FREE MEMBER
    NO Posting or PM's Allowed
    powdermonkey72's Avatar
    Join Date
    Oct 2009
    Last On
    12-03-2012 @ 03:29 AM
    Location
    Stawell, Victoria, The wimmera, Northen Grampians, Kimbarra Pastoral company
    Posts
    33
    Local Date
    05-02-2024
    Local Time
    06:03 AM
    Excellent!

+ Reply to Thread
Page 1 of 3 1 2 3 LastLast

Similar Threads

  1. Look what I found!!!!
    By John Holbrook in forum 1911/1911A1 Service Pistol
    Replies: 15
    Last Post: 06-26-2009, 11:46 PM
  2. I just found this one.....
    By ek42 in forum M1 Garand/M14/M1A Rifles
    Replies: 0
    Last Post: 04-04-2009, 12:28 PM
  3. I found my way over!
    By Michael Petrov in forum M1903/1903A3/A4 Springfield Rifle
    Replies: 14
    Last Post: 03-05-2009, 03:57 PM
  4. I found my way!
    By jerrbear in forum M1903/1903A3/A4 Springfield Rifle
    Replies: 0
    Last Post: 03-03-2009, 07:26 AM
  5. MAS 49/56,Found one.
    By TEDIJR in forum Milsurps General Discussion Forum
    Replies: 1
    Last Post: 07-19-2008, 05:15 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts