-
Legacy Member
Striker Protrusion
I know that a SMLE and a No4 should be 0.040" / 0.050" min / max but what about :
LEC
CLLE
MLM
& any other early Enfield variant.
Are they all the same ?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Mine are not the best, but they are not too bad. I can think of lots of Enfields I'd rather have but instead of constantly striving for more, sometimes it's good to be satisfied with what one has...
-
-
06-14-2010 03:50 PM
# ADS
Friends and Sponsors
-
Advisory Panel
Alan, I don't recall seeing a spec for any of the earlier models anywhere, perhaps someone will know.
The main point is the required protrusion to ignite the ammo used, which I'd think would only have changed if the design of the primer cup and anvil had changed.
-
-