-
No 1 MkIII Stock repair
Hi all, sorry if I'm a bit off topic, but due to the relevance I hope you'll forgive me.
Quite a few No1 MkIII fore ends dissintegrate just like this and I've done this repair on a few of them.
This one is done except for needing a copper/brass reinforcement wire through the rear. Also I have only part fitted the draws so that I can fit it to the actual rifle when I see the bloke.
The fitting of the little metal tie is a very difficult little fit up, for the next one I'll make an appropriate router jig.
This is always a very time consuming job, and it is not financially worthwhile, but it's nice to keep them going any way.
Attachment 15932Attachment 15930Attachment 15933Attachment 15929Attachment 15934Attachment 15931
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
Last edited by tbonesmith; 09-22-2010 at 07:39 PM.
Reason: Better layout and spelling
-
The Following 3 Members Say Thank You to tbonesmith For This Useful Post:
-
09-22-2010 07:38 PM
# ADS
Friends and Sponsors
-
Advisory Panel
Mate, have you got some brass threadwire?
If you need some, email me your address.. I have a bit I can spare... Anything to help someone saving foreends
-
Thank You to Son For This Useful Post:
-