How to fit the ring that holds in place the upper handguard?
I suspect that barrel centering in her groove results from ring correct fitment. Mine doesn't touch fore end forwards trogger screw hole , and it should be ok but the wooden shoulder of fore end, where it sits, seems to be shrinked. Right side soulder is almost tight, while the left one is a bit longer. I also suspect the ring swings at the right fore end shoulder pivoting from left side, that's more firm and tight. Could i restore it with laminate wood or it's a waste of time?
Sorry for my poor technical terms: i called "it" a ring, and the thin parts of wood where it contacts i called "shoulder".
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.