-
FREE MEMBER
NO Posting or PM's Allowed
Wow, pre-war
I put in a bid for $1100 but then it got too rich for me!
http://www.gunbroker.com/Auction/Vie...Item=260808387
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
11-19-2011 08:09 PM
# ADS
Friends and Sponsors
-
Advisory Panel
It went cheap because only some of the parts were correct for assembly. Lots of replacements there. It could have been way more!
-
-
-
Legacy Member
I think you were lucky to get out. Almost $ 2000.00 for a rifle with only the barrel and receiver being correct. The op-rod is correct, rev. number wise, but it's been cut. No front sight seal. Think about how much the correct GHS stock and the flush nut sights will cost, not to mention all the other parts. I think you got out at the right time. Am I missing something here or am I that far behind in current prices ??
Last edited by Joe W; 11-19-2011 at 08:43 PM.
-
-
Legacy Member
The receiver has been annealed which would not be correct for an early 1941 restoration. The cost of a SA GHS stock, rear sight group, bolt, op rod gas cylinder etc would almost run between $1500 to $2000 and you still would have the annealed receiver
-
Register To Reply
