Enfield No 4Mk1* Front sight Adjustment Tool

[logman]

Anyone know where I can buy a front sight cramp for the Enfield No 4 Mk1* Long Branch??? It is a tool that fits over the front sight and has a long screw on one side, with which you screw in and out to move the front sight blade....I have been looking for weeks now and have not found anything. Would appreciate anyone's help on this matter. Thanks

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Claven2]

Apart from e-bay or perhaps BDL Ltd., I'm not sure...?

[ismist]

I found one made by Stan Ward on Surplus rifle .com. Hope this helps.


surplusrifle.com/reviews/lt2/index.asp

[Stan in SC]

Indeed you are correct.Just google "LT-2".And I do ship to Nova Scotia.

Stan

[AzShooter]

Stan I ordered the L2 tool last week. I know it's going to work. BTW do you make a small tool to turn the screw to loosen the front sight on the No 4 Mk 1*?

[Stevo]

Stan I ordered the L2 tool last week. I know it's going to work. BTW do you make a small tool to turn the screw to loosen the front sight on the No 4 Mk 1*?

I made one by cutting a slot in the end of a small brass punch with a wheel on my Dremel. Works perfectly and cost very little.

[AzShooter]

I just made one from a 6 pt wrench in one of my screwdriver sets. It works fine. Thank God for Dremels.

[sakorick]

I just made one from a 6 pt wrench in one of my screwdriver sets. It works fine. Thank God for Dremels.

Can you post a pic of your special tool? Regards, Rick.

[Stan in SC]

I made one from an old screwdriver.It works fine.Just cut off the existing tip and slot it with a Dremel tool or a hacksaw.

Stan

[gandog56]

Fortunately the sights on my new No. 4 MK 1 were spot on.