Enfield Revolver

[bigduke6]

I posted a similar post on another thread, but thought I,d try my luck on here as its an Enfield,

Am looking for any blueprints/ Plans for any of the following, Enfield/ Webley revolvers

If any one can point me in the direction etc, a long story but its for a future project, I,m looking at trying to reproduce one to the UK requirements, this has to be either 24" overall length with a 12" barrel.

Other option is to produce it as a Muzzle loader but would run on Nitro powder like the Westlake Taurus.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[enscien]

You should try the library at the Royal Armouries, Leeds. They inherited all of the material from the MoD pattern Room library and certainly have some of the DD(E) 29A drawings for the Pistol, Revolver, No.2 Mk 1 on negatives/slides .

[bigduke6]

Thanks enscien, will give them a try, was about to give up and buy a deact to back engineer, but the drawing would be a great advantage as it will have all the radius on etc, have to admit I never thought about Leeds.

[Peter Laidler]

Worth a try but not sure that they'll release the manufacturing drawings for a pistol........... Would you?

[bigduke6]

Worth a try but not sure that they'll release the manufacturing drawings for a pistol........... Would you?

With an accent like mine and my location probably not...... but for research purpose etc then maybe. There are plenty of other drawings on the internet available, have a set of engineer drawings for the Walther P38 and the Sten, the Sten ones are on the knowledge libary.