-
Legacy Member
03-A3 Follower Question
Will a milled "1903 Follower" work in my SC 03-A3?
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
01-03-2013 02:00 PM
# ADS
Friends and Sponsors
-
Advisory Panel
yes, but may give you feeding issues.
-
-
-
Contributing Member
Yes, the milled follower will work in your M1903A3, but it can not be installed / removed through the top as a stamped one can. You must remove the trigger guard assy to install or remove it. Installing milled followers in '03A3s was so common by using activities that a caution was added to the TM about it.
-
-
Legacy Member
Thanks for feedback.
I am trying to solve feeding issues. I have correct follower spring, but does not fit follower correctly (as far as I can tell). It causes follower to be pushed to rear and it hangs up. I am thinking of trying a new follower to see if that solves the problem.
-
-
Advisory Panel
sounds like a stock and trigger guard fitting issue.
-
-
TM 9-1270, which is accessible in the "sticky" section above, has a section on inspection procedures. There are max/min dimensions for magazine springs that you may wish to check. Possibly your spring is fatigued and sagging a bit.
-