-
Legacy Member
No4 Headspace bodge
I just had a nice 1941 Maltby Come in to be checked over.
I checked the Headspace & it was fine until I noticed that there was a large burr on the right bearing surface of the action.
What some one had done is peen the action over so that the bolt locking lug was contacting only on the burr on the action, to acheive headspace.
Has anyone else seen such a disastrous bodge, this action is now proably scrap.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
Thank You to Simon P For This Useful Post:
-
01-16-2013 02:46 PM
# ADS
Friends and Sponsors
-
Simon:
What to meet bubba's brother ?
I was cleaning up some junker Metford actions and found this one that has been in the "junque box" for a while. Note the precision work in fitting a SMLE bolt into a Metford with the smaller locking recess.
A work of art to behold.
enjoy.Attachment 39790Attachment 39789
-
Thank You to Warren For This Useful Post:
-
-
Legacy Member
The locking lug is a bit rough, but the dustcover lug looks like a nice neat grafting job...
-
-
Legacy Member
Warren, that bolt is exceptionally bad.
-
-
Legacy Member
-
The Following 4 Members Say Thank You to Simon P For This Useful Post:
-
Advisory Panel
Someone was very proud of his job at getting the rifle to pass headspace. Obviously done to deceive and make a sale. The one Warren has is just brutal...
-
-
Words simply fail me...............
-
Thank You to Peter Laidler For This Useful Post: