-
FREE MEMBER
NO Posting or PM's Allowed
Finish on Recoiless Rifle shells
Good evening everyone...I'm in the process of refinishing the classical 75mm, steel-cased, drill round. In the process(although I was cautious) of removing paint, some of the original finish also came off....Any experience or advise on replacing the "lacquer" finish would be appreciated. My existing 106mm round also is identified on the dummy warhead; any advice? THANKS !!!
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-22-2013 07:21 PM
# ADS
Friends and Sponsors
-
Advisory Panel
What I remember about the 106 was a laquer finish like you say. I doubt it makes that much difference as it won't go through a chamber again.
-
Thank You to browningautorifle For This Useful Post:
-