iver johnson 30 short caliber

[mastervac]

hi everybody

any speciel thing to do to remove an barrel from IVER JOHNSON RECEIVER because after many attempts i cannot unvise the barrel . ANY TRICKS OR TECHNICAL ADVICES ARE WELCOME.

GOD BLESS AMERICAN
U ARE WITH US OR EITHER A ****IN TERRORIST

STEF from France

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[browningautorifle]

They're all about the same. The barrel should have flats along the sides, it can be grabbed in a vise with protective plates but the receiver needs to be cared for. So many areas that can be damaged. Then they come right off, after all they're just a little carbine. You'll almost NEED to have the proper wrench for the receiver. I've done with others but I can't describe how to do it.

[gunsdora]

You need to use a receiver wrench & a good vise. but But first I would get something that you can put the receiver in & part of the barrel were it screws in the receiver & fill the can with a good penetrating oil for about 3 days . Should con off with no problems.