Good Evening All!

I just picked up my first C96, a Bolo. It was advertised as a parts gun, re-barreled, and a good shooter. I disassembled and found it was not matched - no big deal to me, but as I looked at it I couldn't figure out if it would fire. It doesn't appear to me the firing pin will protrude enough to strike the primer. Ammo is a bear, so it will be a while before I can test fire it. Can anyone explain how to bench test firing pin protrusion on these? Unless it works by inertia I can't see how it would ever fire. Thanks!
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.