Hi guys,have a #4 t clone, have some questions about zeroing at 100 yrds. That being said, I read and reread, Peter laidliers, building a clone,and am still confused. I donot have an area I can bore site at 650 yrds, and the local ranges are only 100yrds. I set the turrets on 0 and bore sited the rifle at 100 yrds, then fired some groups, the windage was left about 6inchs, the elevation was shooting 11 inches high. The windage I understand to correct, remove front pad and file the back of the pad to swing the scope left. The elevation I'm not sure i can fix, I can't raise the rear pad. My question is, can I loosen the locking ring, and just lower the grad, to match the poi? Also I'm confused how to zero the adj. drum, I'm under the impression you loosen the locking ring, hold the lead screw, and rotate the drum, then tighten locking ring. Thanks for any input, and sorry for any stupid questions. Don't want to break anything, since parts are unavailable.Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.