-
Legacy Member
When to anneal?
Say it's time to anneal some brass, is it best to size then anneal or anneal then size? Said brass is splitting on the next firing so it's at its end without being annealed.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-28-2015 01:09 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
-
-
Legacy Member
Thanks moose...
-
-
Legacy Member
Speaking of the importance of"sequence":
It's like the errant Viking sitting in a corner, writing out lines:
"Pillage THEN burn
Pillage THEN burn"..........
-
Thank You to Bruce_in_Oz For This Useful Post:
-
Legacy Member
Originally Posted by
Bruce_in_Oz
Speaking of the importance of"sequence":
It's like the errant Viking sitting in a corner, writing out lines:
"Pillage THEN burn
Pillage THEN burn"..........
-
-
Legacy Member
Hello all.
I also anneal after two to three shoots, and have found that these last longer than cases that are left to shoot for longer.
I, of course only anneal the neck and make sure the heat does not go down pass the shoulder, as soon as the right colour is at the neck, i drop the case bottom first in water. To ensure that the same amount of annealing gets to the neck, i rotate the cases in a battery drill in front of the flame by means of an hole saw.. about 3/4'' takes most cases and shields the rest of the case from heat. With the teeth removed from an old hole saw, this makes the perfect tool.
As has been said on this Forum! Drying is gentle!!!
For me the Sun in Summer is fine. In winter, gentle heat from a home Rad is enough.
Never Rush Chaps.
Please Amend where needed.
-
-
Legacy Member
Hole saw,,good idea! I use sockets.
-
-
Legacy Member
I anneal my brass (308 and 303) by holding with my fingers and heat the shoulder until the heat spreads down the case body and the neck becomes dull red then dump it in a bucket of water. I use the pencil flame to do the heating so its very quick. I do several hundred at a time this way. For the 303 British I am getting over 10 reloads with ease unless the BREN eats the brass.
-
-
Advisory Panel
Originally Posted by
Mr E
I use the pencil flame to do the heating so its very quick.
Do you have the flame at a right angle and turn the cartridge in your fingers?
-
-
Advisory Panel
Keeping it simple -
Direct torch at shoulder and the neck takes care of itself without overheating.
No need for water cooling, by the way. Just air cool in a metal pan for 20 minutes and they're ready to reload.
-
Thank You to Parashooter For This Useful Post: