No4T pads

[stevlas58]

Good morning everyone. I'm looking for a source for original No4T scope mount pads for a 1931 trials rifle I'm restoring. Any thoughts?

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Peter Laidler]

To be really honest I think that you'd be better off getting a good repro set and adjusting them to fit. But even that probably wouldn't do because there no chance that the screw holes would even be close to those on the rifle. Get or make a set without the fixing holes and fit them. It's quite simple - IF - you follow the instructions. I won't go into it here but many have done it by doing your homework first then the proper preparation and then following the instructions to the letter

[browningautorifle]

Get or make a set without the fixing holes and fit them.

Didn't we have a thread here where a member took us through the entire procedure of making a set from scratch?

[bigduke6]

Didn't we have a thread here where a member took us through the entire procedure of making a set from scratch?

There is Jim, think its in the Restorers corner or Gunsmithing forum

[Badger]

Didn't we have a thread here where a member took us through the entire procedure of making a set from scratch?

This one Jim?

Fitting & machining of bracket pads blanks on a No#4

Regards,
Doug

[browningautorifle]

This one Jim?

Yes boss...that's the one. That was fantastic...!

[Lee Enfield]

Well I guess that I should have bid on that rifle as I have a set of trials pads...

[browningautorifle]

I have a set of trials pads

This ought to be good...

[snipershot1944]

Let the bargaining begin.

[Promo]

Did you buy the rifle from gunbroker?