-
Nice looking rifles Lance. Are the brackets on rifles 1 & 2 'original matching'? The second is definitely oil finished. Can't be sure about the first.
-
-
11-29-2017 11:44 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Roger, can you talk me through the term "oil finish"? Assume total ignorance on my part.
Thanks!
Rob
-
-
Contributing Member
There's what I think is a Maltby T on Gunstar at the mo' and I've never seen a bracket with so many serials all over it.
-
-
Hi Rob. I think precise methods favoured probably vary a bit from person to person, but essentially it involves heating the bracket & dousing it in engine oil or similar. The oil adhering to the surface is then burned off with a flame, & once burned off a further dunking/application is carried out. This, in turn is burned off, & so the process is repeated several times until a nice reasonably uniform finish is obtained. The best oil is the nastiest filthiest old oil you can find, not new stuff. I've treated a few brackets like this over the years with quite pleasing results. I couldn't get it right at first, until someone gave me some dirty old well used oil.
Last edited by Roger Payne; 11-29-2017 at 04:42 PM.
-
-
Advisory Panel
Nice looking rifles Lance. Are the brackets on rifles 1 & 2 'original matching'? The second is definitely oil finished. Can't be sure about the first.
The first Trial is m/m with scope #1319 on it now; the rifle is all matching with Trials wood, found the original scope can but scope #1186 has yet to cross my path. Trials #2 could be considered matching as the numbers match but the rifle has been reworked a few times and now has later wood, scope can is missing so I cannot confirm it is the mount that left Enfield with the rifle, scope is a Vickers #113
-
Thank You to Lance For This Useful Post:
-
Advisory Panel
It looks to me like #1 and #3 have had rifle serial numbers removed.
-
-
Legacy Member
Dang Your scope #1319, got me excited and had to check my Trials scope number couldn't remember but it sounded familiar, but alas, too bad mine is #1374, close but no cigar, Ray
Last edited by rayg; 11-30-2017 at 04:34 PM.
-
-
Oil blacking or carbon blacking. We were taught to hand the items on wire and get them to a deep cherry red colour and dip into dirty old oil. The oil will flash over when you do it again - and again and again and again. It usually takes several times and then let it hang to dry off. There is another method I learned in NZ and that was blanket blacking. Cherry red again and wipe over with an old wool blanket a couple of times. That was just another method of 'carbon blacking'
-
-
Legacy Member
Oops screwed up, and got mixed up, serial number of the rifle is 1374. Original scope was 6041. Sorry old age taking over, Ray
Last edited by rayg; 12-01-2017 at 10:00 AM.
-
-
Contributing Member
A No. 4 T turned up on gunbroker this night, with what appears to be an original No. 32 Mk.I scope (because it still has the sunshade) and an unmarked bracket - therefore could be the original bracket to the scope. So this would confirm that trials brackets were without any markings, aside of the numbering on the right side and top rings.
http://www.gunbroker.com/item/723006242
-