Afternoon all,

Well I gave up on trying to build up an L2A1 a while back, while the Lithgowicon parts kit (L1A1) parts kit was doable, as was the barrel, getting the L2 specific bipod/gas block combo was problematic and I would be pushing my luck with my FEO explaining why I needed another 7.62mm rifle.

So I reluctantly put the idea on ice...

Enter, Gils L1A1 builder, he's taken up the challenge and done a pretty good job, he just needs the right butt, carry handle and re profile the safety to match as closely as possible the selective fire unit of the L2A1.

I bet this raised a few eyebrows at the Proofhouse.

I salute you sir for pushing the boundaries...

Enfield Guns | Lee Enfield Guns Online | Lee Enfield Rifles
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.