Good Morning

I have 2 magazine springs for my M1903 Springfield (not a3) The one that was in the rifle is slightly taller than the replacement I purchased. The diagonal legs are also slightly longer as well. The width and step down where the spring goes into the follower is the same.

Can you tell me what do I have and what did I buy.

I purchased a new spring because the nose of the follower sometimes gets hung up in the magazine, so I thought it might be worn out.

Somehow I have doubled the pictures and can't seem to figure out how to remove one set.

Thanks

Stuart
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.