-
Advisory Panel
It's best to treat the wood inside and out. Make sure you read Peter's articles on forend fitting and check all the bearings too while you're at it. Don't goop the RLO in the tight inletting, just apply and sweep out the access with a toothbrush because too much buildup can change things, not always for the better. Grease all the metal with XG279 or an equivalent when you reassemble. Keep the screws tight, shoot and enjoy!
-
Thank You to Brian Dick For This Useful Post:
-
05-18-2018 01:55 PM
# ADS
Friends and Sponsors
-
Contributing Member
Here's my new (woodwork freshly RLO oiled up) Faz No5 in action last week, what a hoot to shoot!
.303, helping Englishmen express their feelings since 1889
-
The Following 2 Members Say Thank You to mrclark303 For This Useful Post:
-