Rebore .351 to .357

[rcathey]

Hey all,

I have a “money pit” project in mind and was curious if anyone has any experience with reboring.
The tricky part of this project is the small amount I need cut away.

One site I found said they needed to cut a minimum of .030” away to get a clean cut. Perhaps that was just with their tooling though.

So is boring out a .351 bore to .357, cleanly, possible?

A Winchester 1907 in 38 Super would be pretty cool! But yes, an expensive project

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.