Hello,
I have found a Leatherwood ART II 3x9 rifle scope for my Springfield M1Aicon.
However, I ran into a problem:
The little roll pin to secure the rear rail mount base is missing. I have been told it holds the measure 3/32"x9/16".

When I say the rear rail mount base for the rifle scope, it is the part that substitute the clip guide on the M1A

I found the roll pin for the M1A clip guide at Brownells. However it holdes the measure 3/32" x 5/8", and I suspect it is a bit too long.

Can anybody help me with the correct roll pin for the rear rail mount base for the rifle scope?

Thank you in advance,

Cordially,
Anders

Note: http://www.strandholm.dk/transit/pho...lery/perII.png
Information
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current.