Sleeving a Martini Henry Rifle Barrel

[mmppres]

Sleeving a Martini Henry Rifle Barrel.
I found a carbine in my shop from long ago that some ungrateful person cut a slot across the barrel at the receiver with a saw. I would like to find a .303 barrel sleeve to slide into the barrel an just epoxy it in. then just changing the extractor as needed. Not sure if any one has tried this before or if there is a source for the sleeve. Like to hear your thoughts on this.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.