-
Legacy Member
Keystone stocks?
So can someone tell me how and when a USGI Keystone C Stock was installed on a Remington 03A3? I want to increase my knowledge about the one I acquired.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
06-27-2021 07:46 AM
# ADS
Friends and Sponsors
-
Legacy Member
The only Remington rifle that came from the factory with a C stock was the M1903 A4 Sniper. Any M1903 A3 with a C stock had the stock installed either at a rebuild facility or by anyone who preferred the C stock to a straight stock.
-
Thank You to m1903rifle For This Useful Post:
-
-
Legacy Member
I believe that most (all?) replacement stocks installed by a repair facility will be stamped with an arsenal code on the side, & proof P on the handgrip. A replacement stock with only the maker's code was likely installed after the rifle left the military.
Neal
-
Thank You to Neal Myers For This Useful Post:
-
Legacy Member
I think (without certainty) the P was not put on a spare but only a stamp from the arsenal.
Many A4s had S stock during the conflict. I had a video of the troops in action on the Rhine and briefly saw a sniper with his S butt.
the first models released had more regularly the stock S and the commercial 330 C weaver scope.
I let the professionals of 1903 answer these questions and benefit from their knowledge
Last edited by gigi79; 06-29-2021 at 01:50 PM.
-
Thank You to gigi79 For This Useful Post:
-
Legacy Member
The original production block of 03/A4 rifles was produced with C stocks that were provided by SA but later in production the scant stocks were used. No standard S type stocks were used in original production.
-
Thank You to twh For This Useful Post:
-
Contributing Member
I believe Keystone stocks were used primarily for arsenal rebuilds, I don't think any were used in A4 production?? I picked up mine from a supplier in Holland, who had NOS Keystones about 6 years back .... Took 'some serious' bedding to get it fitted right!
-
Thank You to mrclark303 For This Useful Post: