-
Legacy Member
interesting photo of early follower rods for comp springs
-
Thank You to RCS For This Useful Post:
-
10-07-2022 06:24 PM
# ADS
Friends and Sponsors
-
Contributing Member
The scalloped cut at the end of the arm (non working side, or right portion) is different on the second from bottom.
It appears to be machined differently than the others.
-
-
-
Legacy Member
-
Thank You to cgroc09 For This Useful Post:
-
Legacy Member
-
-
Legacy Member
Wow you guys are sharp! The only difference I can see at all between the bottom one and the rest is the serrations go all the way to the next angle where the other ones stop a little short from the angle. also appears the Winchester is the thickest one on the C shaped part of the follower rod. At first glance they all look the same to me
Last edited by jond41403; 10-08-2022 at 02:31 PM.
"good night Chesty, Wherever You Are"
-