-
Legacy Member
No5 Rear Sight Screw Size
Hi all,
Just wondering if anyone knows the size of the thread used on the No5 singer style sights?
I know its a single pitch, just unsure about the size and TPI.
Im trying to figure out if i can use an No5 elevation screw and modify it to a windage screw on a different sight.
-
-
10-19-2023 07:52 AM
# ADS
Friends and Sponsors
-
Legacy Member
Originally Posted by
pedro243
Hi all,
Just wondering if anyone knows the size of the thread used on the No5 singer style sights?
I know its a single pitch, just unsure about the size and TPI.
Im trying to figure out if i can use an No5 elevation screw and modify it to a windage screw on a different sight.
The No4 (1300yd) sight screw is a 'double thread' screw, the No5 (800yd) sight screw is not only a slighly bigger diameter and a coarser thread it is also just a single thread.
According to the SAIS the "Screw adjusting, backsight" is noted as being a "unique thread only used on the No5".
I guess it will depend on what thread size / type is on the windage sight.
Mine are not the best, but they are not too bad. I can think of lots of Enfields I'd rather have but instead of constantly striving for more, sometimes it's good to be satisfied with what one has...
-
-
-
Legacy Member
From limited amount of measuring I can do without taking one apart, appears to be 0.139 thou with about 38tpi.
-
-
Legacy Member
cheers for the replies.
It is for a trial sight which was used on a No5 .22 trials rifle (Skennerton
, pg297).
Mine has broken off the head so i only have the threaded part left. This is how i bought it, thought it was a common sight but i have been told the right collector may find the sight more valuable than the No.8 rifle its on.
From what i have measured, my thread appears to be 1/8" and about 40 TPI, single pitch. I was thinking of trying to get a jungle carbine elevation screw so i can turn and cut the required thread on the section that isn't threaded. This will allow me to use the standard click section and knurl, which appear to be the same.
-
-
Advisory Panel
One of us probably has one in a box somewhere from a NS sight.
“There are invisible rulers who control the destinies of millions. It is not generally realized to what extent the words and actions of our most influential public men are dictated by shrewd persons operating behind the scenes.”
Edward Bernays, 1928
Much changes, much remains the same. 
-
-
Contributing Member
Originally Posted by
pedro243
1/8" and about 40 TPI,
If the screw is the size you say I wonder how close it is to 1/8" Model Engineering thread which appears to also be 40 T.P.I and is Whitworth form, i.e. 55 degree thread angle.
ME Model Engineer Thread
-
PM
