Search:

EnfieldNutt84,
When I received an SC 03a3 from the CMP I understood that they were made in Syracuse. If you are interested in a Rochester made WWII rifle go to the CMP web site and order a National...

Steve,
You might try Springfield Sporters. Here is a link to their 03/03a3 parts:

http://www.ssporters.com/parts/Springfield%201903.htm


Good luck!

Dave

My apologies, I should have said a finer cut powder them 4064.

4064 would occasionally not flow through the neck into the case and would back up - that is what I met by bridging.

Dave

I had loaded 4064 for sometime in .223. It worked fine, but due to the coarse powder, it would occasionally bridge in the neck of the case. It was noticeable and just a bit of a mess to clean up. ...

John, I just sent you an email with the entire Ruger Mark 1 manual file attached as a PDF file. If it can not get through your email (some have limitations on file size of attachments) let me know...

John,

Unless you follow the manual, it's difficult to figure out.

Go the Ruger website and the Mark 1 manual at:

http://www.ruger-firearms.com/Firearms/PDF/InstructionManuals/48.pdf

See...

I have been shooting my Mossberg US 44 and a fairly new Ruger 10/22T with Tech sights. I shoot reduced size targets for the .22 LR in off hand, sitting and prone. I do have an "adequate" amount of...

Dave,
Thanks very much. I'll bring the rifle to the range in the next couple of weeks and check the adjustment. Another poster send me a PM with a suggestion on doing the measurement at the range...

Can anyone let me know how far a click of elevation and windage adjustment will move the bullet ? I'm asking about a rifle with Mossberg sights.

Thanks in advance.

Dave

Nice looking rifle, I like the pad to get your eye up to the level of scope. 2 MOA is better than I could shoot when I had a Mini 14, but every rifle is different. Have fun with it.

Dave

The lever marked off on the left side is called a magazine cutoff. The purpose was to be able to fire the rifle as a single shot, saving the ammo in the magazine for when it was needed, i.e. rapid...

I have bought new Winchester nickel plated brass cases for loading for my Savage 308 bolt gun. I'll continue using regular brass cases for my M1a.

Aside from straight walled 38 cases I have not...