-
Legacy Member
Inch rear sight loose
My L1A1s' rear sight has developed a side to side movement and groups are showing a horizonal dispersion.
Are there any good fixes to cure this?
I am considered peening, steel epoxy or possible stainless steel tape, to tighten the sight. Wanted to know of any other workable ideas before I try one of my own.
Thanks,
bonnie
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
03-20-2009 08:45 AM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Squeeze it in a vice, slowly and carefully. For more professional advice, go to The FAL Files Forums
-
-
Legacy Member
Are you sure that both screws (1 ea side) are tight?
-
-
Legacy Member
Paul,
Probable should have been clearer in my discription. The ramp is tight. The rear sight leaf and the base have side to side movement on the ramp.
Hagar, Squeezing in a vice sounds better then my ideas.
Thanks
-
-
Sounds like the balls and springs are unserviceable to me! Loose backsights were never a problem in service. Send me your address and I'll send you a complete backsight assembly plus left-right screws and clicker thinggy. No charge except postage
-
-
FREE MEMBER
NO Posting or PM's Allowed
Sounds like the balls and springs are unserviceable to me! Loose backsights were never a problem in service.
Theres a good hint, my rear sight also wobbles all over the place.
I have the dual Hythe type apetures and thought wobble was standard issue.
I better look at that more closely!