-
FREE MEMBER
NO Posting or PM's Allowed
No 4 Feeding issues.
Are there any threads here that address feeding issues of the No4 rifle. I have a stable of No4 rifles and several of them have magazine feeding issues. I have searched and can't find anything to the point.
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
11-16-2013 07:54 PM
# ADS
Friends and Sponsors
-
Legacy Member
Feeding issues are most likely to be magazine related. What I have done is watch how it misfeeds and gently bend the magazine lips to try and get the cartridge pointing in the right direction. You have to be gentle as like any metal, if you get too excited and break a lip off then it won't be pretty. Once sorted, the magazine is meant to stay forever with that rifle.
-
-
-
Contributing Member
Have a geko through P Laidlers threads or similar from other personnel
-
-
Legacy Member
Also remember that the magazine was designed around Mk7 ball, not commercial soft-points.
OK, it should also feed Mk8 ball, but I don't recommend using Mk8 (boat-tails), or any brand of boat-tails for that matter, in a Lee-Enfield that has a few miles on the clock.
Any bullet that is loaded to a shorter length than the OAL of Mk7, or is a radically different profile, or BOTH, WILL give you headaches.
Soft-points, even of "close-enough" profile, MAY also hang-up from time to time.
If you "fiddle" with the front magazine lips, you may get some joy. Too much "fine tuning" and you might be up for a new mag if a lip falls off from metal fatigue.
Softly, softly, and all that.
Welcome, and good shooting!
-
-
FREE MEMBER
NO Posting or PM's Allowed
Mr Wood, here's quite agood illustrated article; I am sure there will be others, too:
To Which I Replied...: Enfield magazine feed lip tuning
Rob
-
Advisory Panel
The Sierra 180 Pro-Hunter flatbase and the Hornady 150 Spire Point both feed very well through anything I have when seated to the OAL of a Ball round.
Neither is MilSpec, but if they feed, then MilSpec will feed also.
Once in a while, gentle tweaking of Mag Lips on a new rifle is useful.
I am running a couple of P-'14s, 5 or 6 Rosses and a dozen or so LEs and LMs, all between 1894 and 1945.
-
-
FREE MEMBER
NO Posting or PM's Allowed
Originally Posted by
RobD
Thanks Rob! This is what I was looking for.
---------- Post added at 09:21 PM ---------- Previous post was at 09:12 PM ----------
Originally Posted by
Bruce_in_Oz
OK, it should also feed Mk8 ball, but I don't recommend using Mk8 (boat-tails), or any brand of boat-tails for that matter, in a Lee-Enfield that has a few miles on the clock.
Ironically, Most, maybe all, of mine shoot the Hornady 174gr and pulled 7.62X54 BT's very well. I think the worst group so far with any of them has been about 5" at 100yds, and that's the extreme. Most of them are at least 3"@100yd (most better) guns with most loads. But luckily, they all have near VG or better barrels and I have taught myself how to properly fit the wood from reading Mr. Laidler and others advise
Last edited by Morning Wood; 11-18-2013 at 09:24 PM.