-
FREE MEMBER
NO Posting or PM's Allowed
long branch troubles
Hi I have had a great looking 1943 longbranch that the say was converted to .308 by longbranch in the 60s with the match parker hale sight on layaway for a while and was in the store looking at it the other day. I then asked a stupid question as there is no visible marking how could we be sure it was actually .308 and they bought out a few snap caps and drilled out empty rounds to show me. that was when the wheels fell off the whole situation as the mag wouldnt hold the rounds properly kept letting them fall out and when they finally got some to stay in it they were so low that the bolt would not pick them up into the chamber? when they loaded a round loose on top of the mag and tried to eject the ejector didnt pop it out instead it pulled it out of the chamber and dropped it into the top of the mag. they tried different mags same result.
any ideas what the h@ll is going on would be greatly appreciated.
could it be a .303 still could it need a special mag, ejector problems or some other major problem.
thanks for any input
Information
 |
Warning: This is a relatively older thread
This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
06-28-2012 01:27 AM
# ADS
Friends and Sponsors
-
Advisory Panel
The mag is still a 303 mag. That's not unusual. They were for match so they didn't have to mag feed. The 7.62 mags are expensive and scarce, but available. The reason it doesn't eject properly is either the mag has the ejector attached or the ejector needs to be installed in the gun. There are two different rigs for this. I had one without either and it shot just fine like it was. Never bothered me a bit. The barrel will be marked with a Canadian
Arsenals mark at the muzzle, on top. I don't recall there being 7.62 marked on mine either.
-
-
-
There's a few articles on the fitting of these repop or factory Enfield 7.62mm magazines. You probably still have a standard .303" extractor too. Start by getting a 7.62mm extractor from Brian at BDL Ltd in SCX. If he has them. They're getting rare now too!
To put your mind at rest, a .303" case won't fully chamber in a 7.62mm rifle and vice verca.
-
-
Advisory Panel
As mentioned above, there were no 7.62mm mags available when these rifles were converted and in use for competition, nor did the users want or need magazines, except as a single loading platform.
Personally I've never seen a DCRA conversion barrel without the "7.62mm" on top of the bbl. near the muzzle, but who knows?
“There are invisible rulers who control the destinies of millions. It is not generally realized to what extent the words and actions of our most influential public men are dictated by shrewd persons operating behind the scenes.”
Edward Bernays, 1928
Much changes, much remains the same. 
-
Register To Reply
