No.4 Mk2 Front Trigger Guard Screw Bushing Lenght

[ptf18]

Should the Trigger Guard Screw Bushing protrude above the stock wood? Mine does by approximately 1'/16". That doesnt seem correct but I thought I'ld ask before the grinder came out. Seems that the Guard would bottom out on the bushing and not "pull" against the stock.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[Peter Laidler]

Put the grinder away and read the article about fitting fore-ends. The subject of the length of the collar has been aired on this forum about 20 times. Read up and do it properly is my suggestion

[ptf18]

Thanks peter. Dumby me.