-
Legacy Member
Standard Products Rear Sight
Is it possible that SP #2177xxx could have had a type II rear sight originally? Thanks.
vern
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
-
01-28-2011 10:15 PM
# ADS
Friends and Sponsors
-
Legacy Member
In 1944 SP made over 100,000 carbines by April
The adjustable sights started showing up about that time. The question is: did SP get a supply or even want them? Winchester was using a mix of types but they were a big time producer. Are there any signs of staking on the receiver? It is sometimes just a light strike. BQ will know. If I recall SP didn't use all their numbers, so yours could be late
Last edited by DaveHH; 01-28-2011 at 11:16 PM.
-
-
-
Senior Moderator
(Milsurp Forums)
I have seen a number SPs with earlier serial numbers with both type II and type III sights.
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
-
Legacy Member
-