-
FREE MEMBER
NO Posting or PM's Allowed
Try a carbide end mill in a hand drill . Take your time it will work.
-
03-30-2012 07:47 PM
# ADS
Friends and Sponsors
-
FREE MEMBER
NO Posting or PM's Allowed
Thanks for all the helpful ideas. Mike D, your starter punch suggestion was the ticket. First, I chucked the pin punch into my cordless drill and used a file to turn it down to .055". Then I heated the sight block with a propane torch and gave the pin a healthy SCHMACK with the solid punch, which loosened it enough to complete the task with the pin punch.
Thanks, again!
-