-
FREE MEMBER
NO Posting or PM's Allowed
Issue with front sight base alignment with rear sight
On my M16A1 clone, I have the rear sight moved as far right as it can go. The rifle still shoots about 1 MOA to the left at 100 yards. What can I do to fix this? --TIA
Information
|
Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current. |
|
-
03-26-2015 03:43 PM
# ADS
Friends and Sponsors
-
Advisory Panel
That's right, it's not that common but we do hear of it here. Like Steve says, just get the front squared up or if it's a new barrel, it should have a warranty. I did have a flat top that was machined off square on the top too...
-
-
-
Senior Moderator
(Milsurp Forums)
I have also seen uppers with a "spacious" index slot that allows the barrel to twist just enough to throw the alignment off.
Bill Hollinger
"We're surrounded, that simplifies our problem!"
-
The Following 3 Members Say Thank You to Bill Hollinger For This Useful Post: