-
Legacy Member
Salu2 a to2
Bizio
FISAT Life Member & NRA Life Member
-
-
07-16-2013 09:15 AM
# ADS
Friends and Sponsors
-
Overall condition appears to be good. I think more pictures would have been nice. No barrel markings shown.
I can see a hand stamped M2 marked receiver, M2 cut stock, and a 30 round mag. Do you know what the internals are?
Nice sling and mag pouch. The pouch covers the stock area where the cartouche would be.
When you go see him, I would ask to break it down.
If the only M2 part is the receiver ring, is the asking price in line with carbine sales in your country?
-
Thank You to JimF4M1s (Deceased) For This Useful Post:
-
-
Legacy Member
Thank you for your answer, JimF4M1s.
Unfortunatly I don't know any further detail about that carbine.
We have really very few M2 carbines in Italy so I will take it anyway.
Sale price is €800 which is about $ 1,000
A good M1 Carbine is up to $1,500 here.
We have many at lower price but with unmarked stocks and not original parts.
Last edited by Bizio; 07-16-2013 at 10:49 AM.
Salu2 a to2
Bizio
FISAT Life Member & NRA Life Member
-
-
Advisory Panel
Good enough then, when in hand...you can give us a full pic collection. This will prove most interesting in the end.
-
Thank You to browningautorifle For This Useful Post:
-
Legacy Member
When I get the carbine I will do that for sure.
Salu2 a to2
Bizio
FISAT Life Member & NRA Life Member
-
-
Legacy Member
Most likely is an M2 receiver only since the 'happy switch' is not there. In the USA it would be 'verboten' because the bare receiver alone is considered a machine gun. Watch out for a couple of high-wear indicators sometimes found on M2s - grooves in the feed ramp from each side of the magazine and excessive wear in the slide retaining tab and receiver slide-way. The wear on the feed ramp is not critical in operation but is just an indication to check the receiver carefully. Sometimes the upper rail of the slide-way is so worn that the slide will pop out and the wear arch on the bottom of the top receiver rail can be seen with the naked eye. There is really no feasible fix for this wear. Sometimes most of the wear is on the slide tab and a new slide makes it shootable. It looks like it has a replacement slide so the previous owner may have already run into this. The slide should not be tight, but it must not pop out when pulled to the right when operating the slide, until it gets to the takedown notch.
-
Thank You to INLAND44 For This Useful Post:
-
Legacy Member
Thanks, for sure some internal parts (for the full auto) have been removed since machine gun are forbidden to civilians also in Italy.
Salu2 a to2
Bizio
FISAT Life Member & NRA Life Member
-
-
Legacy Member
-
-
On the barrel that looks to be a lightly struck or partially worn W.
-
Thank You to JimF4M1s (Deceased) For This Useful Post:
-
Legacy Member
Yes, that should be a Winchester barrel, late production.
Last edited by Bizio; 07-18-2013 at 04:59 AM.
Salu2 a to2
Bizio
FISAT Life Member & NRA Life Member
-