+ Reply to Thread
Page 1 of 2 1 2 LastLast
Results 1 to 10 of 11

Thread: Disastor at CMP games vintage match with mk4

Click here to increase the font size Click here to reduce the font size
  1. #1
    FREE MEMBER
    NO Posting or PM's Allowed
    Pelago's Avatar
    Join Date
    Mar 2009
    Last On
    01-20-2010 @ 11:31 AM
    Location
    rural NC
    Posts
    107
    Local Date
    05-24-2024
    Local Time
    03:43 PM

    Disastor at CMP games vintage match with mk4

    took a savage mk 4 (1942) virtually unfired, almost new condition to the CMPicon games to use in vintage match, had some south african 303 to shoot at 200 yards

    problems:

    at prone position the stock is so low that i had to rest chin onstock to see thru sights

    started off with rear sight at the 200 yard mark, first shot was almost a paper miss at 7 oclock on cardoard almost not even on the target frame. moved to the 400 yard mark and only move the strike up about 6 inches still a full 24" to the left..

    had to put rear sight at almost 600 yards to equal the center of black, but still 24 inches to the left..

    no windage adjust at all, sight had been drifted somewhat in the past.

    had to pick up a imaginary spot on the right side of target to get into blac

    not a good day

    and previous day i had shot the M! and missed hi shooter by X's
    Information
    Warning: This is a relatively older thread
    This discussion is older than 360 days. Some information contained in it may no longer be current.

  2. # ADS
    Friends and Sponsors
    Join Date
    October 2006
    Location
    Milsurps.Com
    Posts
    All Threads
    A Collector's View - The SMLE Short Magazine Lee Enfield 1903-1989. It is 300 8.5x11 inch pages with 1,000+ photo’s, most in color, and each book is serial-numbered.  Covering the SMLE from 1903 to the end of production in India in 1989 it looks at how each model differs and manufacturer differences from a collecting point of view along with the major accessories that could be attached to the rifle. For the record this is not a moneymaker, I hope just to break even, eventually, at $80/book plus shipping.  In the USA shipping is $5.00 for media mail.  I will accept PayPal, Zelle, MO and good old checks (and cash if you want to stop by for a tour!).  CLICK BANNER to send me a PM for International pricing and shipping. Manufacturer of various vintage rifle scopes for the 1903 such as our M73G4 (reproduction of the Weaver 330C) and Malcolm 8X Gen II (Unertl reproduction). Several of our scopes are used in the CMP Vintage Sniper competition on top of 1903 rifles. Brian Dick ... BDL Ltd. - Specializing in British and Commonwealth weapons Specializing in premium ammunition and reloading components. Your source for the finest in High Power Competition Gear. Here at T-bones Shipwrighting we specialise in vintage service rifle: re-barrelling, bedding, repairs, modifications and accurizing. We also provide importation services for firearms, parts and weapons, for both private or commercial businesses.
     

  3. #2
    Deceased August 5th, 2016 goo's Avatar
    Join Date
    Mar 2009
    Last On
    08-29-2009 @ 03:01 PM
    Location
    mattituck new york
    Posts
    504
    Local Date
    05-24-2024
    Local Time
    04:43 PM
    i'm guessing that its probably better to shoot a rifle a time or two before using it in a match.
    ...
    Two usaf airmen were driving across country on leave. They come to a Marine Corps base and decide to visit. They approach the gate and the Marine Guard walks up to the driver's window, and taps on it with his nightstick. The driver rolls down the window, and the Marine smacks him in the head with
    the stick. The driver says, Why'd you do that?
    The Marine says, You're on a United Statesicon Marine Corps Base, son. When I come up to your car, you'll have your ID card ready.
    Driver says, I'm sorry, We're in the Air Force, and we didn't know.
    The Marine examines the I.D. card and gives it back to the driver.
    The Marine walks around to the passenger side and taps on the window. The passenger rolls his window down, and the Marine smacks him with the nightstick.
    The passenger says, What'd you do that for?
    The Marine says, Just making your wishes come true.
    The passenger says, Huh?
    The Marine says,
    "I know that as soon as you pull away you're gonna say, 'I wish that sucker would've tried that **** with me!"
    Last edited by goo; 05-12-2009 at 10:28 AM.

  4. Avoid Ads - Become a Contributing Member - Click HERE
  5. #3
    FREE MEMBER
    NO Posting or PM's Allowed
    Pelago's Avatar
    Join Date
    Mar 2009
    Last On
    01-20-2010 @ 11:31 AM
    Location
    rural NC
    Posts
    107
    Local Date
    05-24-2024
    Local Time
    03:43 PM
    Thread Starter
    maybe so, but never ever got a rifle off the rack ready to be issued that was off by four feet at 200 yards..

    and test fired a bunch of m14's thru the years and never found one that did not fire at least in the 8 ring off the bench with guesswork elevation for first round

  6. #4
    (Deceased April 21, 2018) John Sukey (Deceased)'s Avatar
    Join Date
    Nov 2006
    Last On
    05-14-2012 @ 06:03 PM
    Location
    Tucson Arizona
    Posts
    762
    Local Date
    05-24-2024
    Local Time
    01:43 PM
    Sounds like you need to check the bedding, looks like the forend is a bit warped and bearing on one side of the barrel

  7. #5
    Advisory Panel
    Peter Laidler's Avatar
    Join Date
    Jul 2008
    Last On
    Yesterday @ 03:50 PM
    Location
    Abingdon, Oxfordshire. The home of MG Cars
    Posts
    16,521
    Real Name
    Peter Laidler
    Local Date
    05-24-2024
    Local Time
    09:43 PM
    Without any doubt whatsoever, this is a classic but extreme case of an ill fitting fore-end. We wouldn't even try to correct it and in this case, the fore-end would be diverted to the DP tray for fitting to a DP rifle at some later date. Waste not, want not as we used to say

  8. #6
    FREE MEMBER
    NO Posting or PM's Allowed
    Pelago's Avatar
    Join Date
    Mar 2009
    Last On
    01-20-2010 @ 11:31 AM
    Location
    rural NC
    Posts
    107
    Local Date
    05-24-2024
    Local Time
    03:43 PM
    Thread Starter
    another question, are all enfield stocks the same as far as comb height, my cheekweld on the us military rifles give a clear sight picture thru all apertures

    with the brit rifle, the same cheekweld gives me a clear sight of the back of the bolt..

    quite a bit of difference in ht, when a dowel inserted thru the barrel and distance between center of dowel and top of stock is measured it is clear that the difference is astounding between M1,03,03A3, M1Aicon and MK4

  9. #7
    Advisory Panel tiriaq's Avatar
    Join Date
    Oct 2006
    Last On
    Today @ 03:44 PM
    Location
    Central Ontario
    Age
    78
    Posts
    1,081
    Local Date
    05-24-2024
    Local Time
    04:43 PM
    Enfields have low combs. Just how they are. Target shooters were allowed to drape a piece of sheepskin shearling, etc. over the comb. Basic zeroing is done at 30 yards, elevation zero is obtained by changing foresights. Windage by shifting the front sight laterally. With the amount your rifle is off, its unlikely windage could be zeroed simply by moving the foresight.

  10. #8
    Advisory Panel Parashooter's Avatar
    Join Date
    Dec 2008
    Last On
    Today @ 04:17 PM
    Location
    Connecticut
    Age
    79
    Posts
    679
    Local Date
    05-24-2024
    Local Time
    04:43 PM
    Try the "spot weld" (something I was taught as a recruit at Fort Dix when the M14icon was brand new). The cheekbone rests on the thumb of the firing hand, providing consistent head position.



    The "combless" Lee-Enfield stock was designed for an upright head position that was in fashion during the late 19th century and early 20th. Face contact is along the side of the jaw rather than high on the cheek. In the offhand position, it's actually a reasonably solid and comfortable position once learned.

    The observaton that this is very different from US rifles is accurate only for US stock designs adopted after WWI. As can be observed in the image below, the critical distance from line-of-sight to comb is actually slightly greater with the original 1903 Type S stock than with the Lee-Enfield. The '03 Type C and "scant" stocks do have a higher comb, as do the similarly-dimensioned M1 and M14 stocks.



    FWIW, your Savage Lee-Enfield, is a Number 4, Mark 1 - not a "Mk 4."

  11. #9
    FREE MEMBER
    NO Posting or PM's Allowed
    Pelago's Avatar
    Join Date
    Mar 2009
    Last On
    01-20-2010 @ 11:31 AM
    Location
    rural NC
    Posts
    107
    Local Date
    05-24-2024
    Local Time
    03:43 PM
    Thread Starter
    and to add that the rear sight had to be on the 400 yard mark made it even higher. i do know that could be adjusted out with some front sight work

    shot prone with a c stock 03 and shot a 99/5 (one snuck out)

    cleaned it with the M1icon

    shot prone with the brit and did hit black a few times using my imagined spot at 3 oclock on cardboard

    "your Savage Lee-Enfield, is a Number 4, Mark 1 - not a "Mk 4.

    oops

  12. #10
    Legacy Member Sunray's Avatar
    Join Date
    Mar 2009
    Last On
    03-29-2021 @ 03:01 PM
    Location
    London, Ontario
    Posts
    1,053
    Local Date
    05-24-2024
    Local Time
    04:43 PM
    "...cheekbone rests on the thumb..." Hurts like an SOB with a No. 4.
    "...virtually unfired..." So you had never fired it before you took it to a match? Shame on you.
    Did you check the headspace at least? Even an all matching rifle gives no guarantee the headspace is ok.
    "...the stock is so low..." You're holding it incorrectly. Too low on the shoulder. It's also possible the butt stock is the wrong length for you. Butt stocks come in several lengths.
    "...no windage adjust at all..." Windage is adjusted with the front sight. Move it in the opposite direction you want the group to go.
    Spelling and Grammar count!

+ Reply to Thread
Page 1 of 2 1 2 LastLast

Similar Threads

  1. ammo at the Eastern games
    By John Beall in forum M1 Garand/M14/M1A Rifles
    Replies: 4
    Last Post: 05-11-2009, 03:17 PM
  2. The Armalite AR-10 (Vintage Promotional Video)
    By Badger in forum M16A2/AR15A2 Rifles
    Replies: 2
    Last Post: 03-23-2009, 01:57 AM
  3. Replies: 1
    Last Post: 08-06-2007, 04:15 PM

Tags for this Thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts