Inch pattern L1A1 barrels

[AK-103 Dude]

I am looking in to building my own L1A1. I have seen a few us made barrels at apex gun parts as well as a few other places. My question is this. Would the apex inch cut barrel that has metric threads work on an inch receiver from coonan? I want to use a us barrel as a 922r compliance part. Any thoughts would be appreciated.

Information

Warning: This is a relatively older thread This discussion is older than 360 days. Some information contained in it may no longer be current.

[AK-103 Dude]

After doing alot of research on thefalfiles.com i have come to the conclusion that saf Lithgow made the best us made L1A1 barrels. I just ordered a brand new one from ernst armory if anybody is still looking. They are also available from rpospecialties page.

---------- Post added at 03:38 PM ---------- Previous post was at 03:31 PM ----------

I dont believe there ever was any particular scope made for match L1A1 rifle but then again i could be wrong. I looked in Ian Skennerton's handbook as well as a few other books on the FAL and only saw the SUIT and a few one-off scope mounts issued in limited numbers.