My Uncle just dropped off his old style 3 screw Ruger .357 single action Blackhawk.
Like most of his guns it's been neglected.
Would anyone have a breakdown guide I could copy to R and R this thing?
TIA,
Charlie-painter777
Printable View
My Uncle just dropped off his old style 3 screw Ruger .357 single action Blackhawk.
Like most of his guns it's been neglected.
Would anyone have a breakdown guide I could copy to R and R this thing?
TIA,
Charlie-painter777
Did you try the Ruger site, they show some information there.
here ya go..
Exploded View's
To remove the base pin completely, you will need to remove the ejector housing.
Be sure to trap the mainspring with a paper clip through the strut hole. Remember which direction the front of the strut is in before re-assembly.
Remove the legs of the triggerspring from their support posts. You can remove the spring entirely if it makes re-assembly easier for you.
Pay attention to the bolt spring and plunger in the trigger guard when you remove the grip frame. Also the hand spring & plunger in the rear of the frame.
Other than that, it is pretty much straight foward.
HTH,
Emri